Homemade Anti-fog Solution for Goggles: 4 Simple Steps That Work
Make a homemade anti-fog solution for goggles with two common household ingredients. Learn the mixing ratio, application steps and mistakes to avoid.
Updated November 2026
A homemade anti-fog solution for goggles can keep your lenses clear for a full training session when it is applied correctly. The mix uses a few household ingredients, takes about five minutes, and works best on swim goggles with polycarbonate or similar lenses. This guide covers the ingredients, the application steps and the mistakes that cause fogging to return.
What You Need Before You Start
Gather these supplies so the process goes quickly and the lenses stay clean:
Shopping for one? See our guide: Swimming Goggles Anti Fog Solution: 5 Best Picks Compared (2026).
- A small bottle or container with a tight lid, such as a 2-ounce travel bottle
- A few drops of mild, fragrance-free baby shampoo or dishwashing liquid
- Clean water, preferably distilled, to avoid mineral residue
- Soft microfiber cloths
- Your goggles, with the lenses clean and dry
How to Mix a Basic Homemade Anti-Fog Solution
Most home recipes rely on a small amount of mild surfactant. The surfactant spreads a thin film of water across the lens instead of letting it form droplets, which is what makes the view blurry. Manufacturers of commercial anti-fog products use similar principles, though their formulas are more refined.
- Fill the bottle about three-quarters full with distilled water.
- Add one to two drops of baby shampoo. More soap does not improve results and can leave a film.
- Close the lid and swirl gently. Do not shake hard, because foam makes the mixture harder to apply evenly.
- Label the bottle and store it at room temperature. Replace it every few weeks, since water-based mixtures can grow bacteria.
How to Apply the Solution to Your Goggles
Application matters as much as the mixture. Apply the solution to clean, dry lenses, then remove the excess so the film stays thin.
- Wash the lenses with mild soap and rinse them well. Oils from skin or sunscreen will block the solution from bonding.
- Dry the lenses with a microfiber cloth, avoiding any lint or paper towels.
- Put two or three drops on each lens and spread them with a clean fingertip, covering the full surface, including the edges.
- Let the solution sit for about 30 seconds. Then rinse briefly in water or wipe off the excess with a dry cloth, leaving only a faint film.
- Do not rinse again after this step, or the film will wash away.
Tips for Drying Time
Allow the lenses to air dry for a few minutes before putting the goggles on. Breathing on the lenses or pressing them against a warm face while still wet can disturb the film.
Common Mistakes That Cause Fogging
- Using too much soap, which leaves streaks and can sting the eyes.
- Applying the solution to dirty lenses, which prevents an even coat.
- Rinsing after the final wipe, which removes the protective layer.
- Storing the mixture for months, which reduces its effectiveness and can cause contamination.
- Rubbing the lenses with a rough cloth, which scratches the surface and creates spots where fog forms more quickly.
Recommended Gear
If you prefer a ready-made option alongside a homemade mix, a commercial anti-fog spray designed for swim goggles is a reasonable backup. For example, TYR Anti Fog Spray is a common choice among swimmers. View on Amazon
A soft microfiber cloth helps you apply and buff the solution without leaving lint or scratches on the lenses. View on Amazon
For background on how commercial sprays compare with home recipes, see DIY Anti Fog Spray for Goggles: 5 Simple Recipes That Work and Swimming Goggles Anti Fog Spray: How to Stop Fogging in 7 Steps.
FAQ
How long does a homemade anti-fog solution last on goggles?
Most swimmers find the film lasts through a single session, sometimes longer in cool water. It typically wears off after several hours or after the lenses are rubbed or rinsed repeatedly.
Can I use vinegar or other household liquids instead?
Vinegar is acidic and can irritate eyes and damage some lens coatings, so it is not recommended. Stick with a mild, fragrance-free soap in water.
Is a homemade solution safe for the eyes?
A very dilute mild soap is generally well tolerated, but if you have sensitive eyes or notice redness or stinging, stop using the mixture and consult an eye care professional.
Conclusion
A homemade anti-fog solution for goggles is simple to make and works well when the lenses are clean and the film is kept thin. Use only a drop or two of mild soap, apply it to dry lenses, and avoid rinsing after the final wipe. Replace the mixture regularly and consult a professional if your eyes react poorly.
Related reading
- Homemade Anti Fog for Goggles: 5 Recipes That Actually Work
- Anti Fog Solution for Goggles: 7 Steps to Clear Swim Views (2026)
Ready to choose one?
