How to Clean Inside of Anti Fog Goggles Without Ruining the Coating
Learn how to clean inside of anti fog goggles safely, with a gentle step-by-step method that protects the coating and keeps lenses clear longer.
Updated November 2026
Learning how to clean inside of anti fog goggles takes about five minutes and protects the coating that keeps your lenses clear. The inside lens collects sunscreen residue, body oils, and dried chlorine that cause fogging faster than anything else. A gentle rinse, a soft cloth, and a little patience will restore a clean interior without stripping the anti-fog layer.
Why the Inside Gets Dirty and Fogs
Anti-fog coatings work by spreading condensation into a thin, even film instead of letting it form droplets. Oils and residue break up that film, so tiny beads of moisture form and scatter light. Sunscreen, lotion, and the natural oil on your skin are the most common culprits. Chlorine and salt crystals also build up over time and leave a hazy film that looks like fog even when the coating is intact.
Shopping for one? See our guide: 7 Best Anti Fogs for Ski Goggles: Expert Picks for Clear Days on the Slopes.
Step-by-Step Cleaning Method
- Rinse the goggles in lukewarm fresh water. Hot water can soften the seal and stress the lens.
- Remove the strap-free lens area from direct sun, then hold the goggles with the inside facing up.
- Add one drop of mild, fragrance-free dish soap to your fingertip and work it gently across the interior lens in small circles for about 10 seconds.
- Rinse thoroughly under lukewarm water until no soap film remains. Run your finger across the lens to check for slickness.
- Pat the lens dry with a clean microfiber cloth. Avoid paper towels, which can leave lint and scratch the surface.
- Let the goggles air dry for a few minutes before storing them.
Handling Stubborn Residue
If haze remains after a soap wash, soak the goggles in lukewarm water for 10 to 15 minutes, then repeat the gentle rub. Do not use alcohol, acetone, or abrasive pads. These can strip the coating and leave permanent cloudiness. If the lens still fogs quickly after cleaning, the coating may be worn, and a reapplication may be needed.
Tools and Supplies Checklist
- Lukewarm fresh water
- Mild, fragrance-free liquid dish soap
- Soft microfiber cloth
- A clean, dry storage pouch or case
Factors That Affect How Often You Should Clean
Clean the inside after every session if you use sunscreen, and rinse after each open-water swim where salt and sand can settle on the lens. Frequent pool swimmers may only need a full interior wash once a week. Goggles used in hot climates or on long training days tend to accumulate residue faster, so a quick check before each session helps. For another angle, check out How to Clean Deck Shoes: A Step-by-Step Guide for Salt-Stained Pairs.
Common Mistakes
- Using toothpaste or scouring powder, which scratches the lens and damages the coating.
- Rubbing with a dry tissue, which can drag grit across the surface.
- Applying anti-fog spray on top of residue instead of cleaning first.
- Storing wet goggles in a sealed bag, which traps moisture and can cloud the lens.
- Leaving goggles in a hot car, where heat can warp the lens and break down the coating.
Recommended Gear
A soft microfiber cloth is the safest tool for drying the lens without scratching it. View on Amazon
A fragrance-free mild soap keeps residue from building up on the inside, and it avoids the solvents that can harm the coating. View on Amazon
A hard protective case stops goggles from being crushed in a bag, which can warp the lens and break the seal. View on Amazon
For more on keeping the coating intact, see How to Maintain Anti Fog Goggles: 6 Steps for Lasting Clear Lenses and How to Fix Anti Fog Goggles: 6 Steps to Clear Lenses Again. If you are considering removing an old coating entirely, read How to Remove Anti Fog Coating from Swim Goggles: A Step-by-Step Guide first.
FAQ
Can I use toothpaste to clean the inside of my goggles?
No. Toothpaste contains abrasives that scratch the lens and can dull the anti-fog coating. Stick with mild soap and water.
How do I know if the anti-fog coating is gone?
If the lens fogs quickly even after a thorough cleaning, the coating is likely worn. Cleaning restores clarity only when the coating is still present.
Should I clean goggles before or after swimming?
Rinse them before and after each session, and do a full interior wash when you notice residue or haze. Regular rinsing prevents buildup.
Conclusion
Cleaning the inside of your goggles with lukewarm water, a drop of mild soap, and a microfiber cloth keeps the anti-fog coating working. Avoid harsh solvents and abrasives, and store goggles dry in a protective case. A consistent routine will keep your lenses clear session after session.
Related reading
- How to Clean Anti Fog Goggles Without Ruining the Coating: 6 Steps
- Swimming Goggles Anti-Fog Restorer: How to Restore Clear Lenses in 7 Steps
Ready to choose one?
