Durafast Elite Solid Jammer Swimsuit: How to Choose the Right Fit (2026)
Learn how to pick, size and care for a durafast elite solid jammer swimsuit so it fits well, holds up to chlorine and lasts through pool and open-water training
Updated November 2026
A durafast elite solid jammer swimsuit is a training-focused jammer built from a durable, chlorine-resistant fabric in a solid color. This guide walks you through checking the fit, choosing the right size and caring for the suit so it lasts. You will finish knowing whether this style suits your training and how to get it on your body without guesswork.
What Makes a Solid Jammer Suit Different
A jammer covers roughly from the waist to the upper thigh, which gives you more coverage than a brief and less drag than a full-length racing suit. Solid versions skip the printed panels, which many swimmers prefer because the fabric is generally more consistent in how it stretches and recovers. The Durafast line is marketed for repeated pool use, so manufacturers typically emphasize abrasion resistance and color retention over raw speed.
If you are comparing styles before you buy, the TYR Men's Durafast Elite Solid Jammer Swimsuit Review (2026) covers how this specific model is built, and Jammer Swimsuit Size Chart: How to Measure and Pick Your Fit (2026) is worth reading before you order.
How to Size a Durafast Elite Solid Jammer
Sizing is where most people go wrong. Manufacturers usually publish a size chart based on waist and hip measurements, and jammers tend to run snug when new because the fabric has not yet relaxed. Follow these steps:
- Measure your natural waist with a soft tape, keeping the tape level and not pulled tight.
- Measure your hips at the widest point, usually about 7 to 8 inches below the waist.
- Compare both numbers to the brand chart, and use the larger size if your measurements fall between two sizes.
- Check that the waistband sits flat and does not roll when you bend forward.
Checking Fit in the Water
Dry-fit checks only tell you so much. Once you are in the water, the suit should stay in place during a flip turn and a few kicks with a board. If the leg openings pinch or the suit creeps down during a dolphin kick, the size is likely too small.
Caring for the Fabric So It Lasts
Chlorine and sunscreen break down elastic fibers over time, and the solid color can dull as well. Rinsing the suit in cool fresh water immediately after each session makes a measurable difference in how long the stretch holds. Avoid wringing the fabric, and dry it flat in the shade rather than on a hot surface or in direct sun.
Recommended gear
A few supporting items help you get the most out of a training suit.
- A mesh gear bag keeps wet suits separate from dry clothes and lets the fabric breathe between sessions. View on Amazon
- A set of extra-wide suit-drying hangers prevents shoulder stretching when you hang a wet suit to dry. View on Amazon
- A pool-safe, unscented rinse soap removes chlorine residue without leaving oils that can weaken elastic. View on Amazon
Common Mistakes to Avoid
- Sizing down to get a “racing” look, which often causes the leg openings to dig in.
- Leaving the suit in your bag after a session, where trapped moisture and chlorine accelerate wear.
- Wearing the suit in a hot car or on a deck in direct sun for long periods.
- Judging fit only on dry skin, since the fabric can feel different once wet.
- Using fabric softener or bleach, both of which can break down the elastic.
FAQ
How do I know if my durafast elite solid jammer swimsuit is too small?
If the leg openings leave deep marks or the waistband rides up during kicks, the suit is probably too small. A well-fitting jammer should stay in place without feeling restrictive when you breathe.
How often should I replace a training jammer?
Replacement timing depends on how often you swim and how well you rinse the suit. Signs it is time to replace it include visible thinning, loss of stretch, or color that no longer looks even.
Can I wear a durafast elite solid jammer for open-water swimming?
Many swimmers wear jammers in open water, though colder conditions may call for additional layers. Check the manufacturer’s guidance for your specific water temperature and activity.
Conclusion
A durafast elite solid jammer swimsuit works best when you size it from measured waist and hip numbers and confirm the fit in the water. Rinse it after every session and dry it flat to protect the elastic. Consult the brand’s size chart and a knowledgeable coach if you are unsure which size suits your build.
Related reading
- Speedo Men's Swimsuit Jammer ProLT Solid Review: Features and Performance
- TYR Alliance Splice Jammer Swimsuit Review: Features and Performance
Ready to choose one?
